It’s easier to do your own drywall repair than you might think. Here’s how you can repair the drywall and other walls in your home that might have been destroyed. You just need to do DIY fixes to patch damaged drywall. If a doorknob is broken or if there’s a hole in your drywall, don’t panic. Even a beginner can complete a nearly invisible repair of drywall with a little patience, some joint compounds, and a few dabs of paint. 

How to Repair Large Holes  

First, determine the drywall’s thickness. The most common ones installed in homes measures half an inch thick. Look for a scrap that’s large enough to patch the broken piece in your home. That’s better than buying the full 4 x 8 feet board. Cut the patch to fit and fasten it, spacing the screws every 6 inches. The trickiest part of how to repair drywall work is to paint the edges of the patched drywall to make it blend. Purchase a drywall compound and a paper tape roll.  

You can also use mesh tape, although it’s not as effective. If you have a lot of fixes, buy a 20-minute set-up compound as well. It allows the patch to harden easily and it will not compress. Before adding the joint tape, use it to cover cracks and gaps.  

How to Patch Medium-Sized Holes 

When fixing walls, always check for wires. Check for any obstruction in the wall before taking out the damaged area. This is how you fix the drywall. You will often find a cable, a pipe, or a channel behind the wall. Use a keyhole saw to work carefully on the walls.  

Make a shallow cut by sawing to start a hole patch. You may also use a sharp utility knife. Adding backer board is easier than trying to cut the drywall over the studs. Simply use a drywall saw to cut out that part. 

How to Patch Small Holes  

Small holes are usually created by screws, hooks, wall fasteners, and drywall fasteners. They pop up from time to time and they’re easy to repair. But it is time-consuming work as it is. Again, as you must repaint the walls. Nail pops are normal yet particularly annoying because it’s likely that there’s more than one. Sometimes, drywall screws pop up due to the damp framing that dried out and shrunk during the new construction. 

The first step in patching small holes in the wall is to use a push the nails back down. Remove the drywall adhesive using a utility knife. If there are screws, lock them tightly with a screwdriver. Be careful not to crush the center of the drywall.  

Using a sharp utility knife, cut off any tears in the wall. This is also a good technique when using drywall fasteners. Taping them directly into the wall is usually easier than taking them out. If you need help with repairs, contact the best Drywall Contractor in Boise to help you out. They will do the job faster and more efficiently for you.